In this master thesis, the technology of turning is discussed, where it is presented from the general part to the technology of turning with intermittent cutting with its specifics. This turning technique was developed by M4 Sciences, and the full name of the technology is "Modulation Assisted Processing" abbreviated MAM. The tools for turning and processing of parameters in the basic technology of turning are described, and especially for turning with intermittent cutting, the technology itself, turning mechanics, temperature analysis of tools. The last theoretical part that would cover this thesis relates to vibrations that occur due to turning. Their division and their impact on economy and final performance in turning are presented. Finally, the experimental part was carried out in the laboratory of the Faculty of Mechanical Engineering in Slavonski Brod, which is located in the complex of the Đuro Đaković factory. Under the leadership of Dr. sc. Miroslav Duspara, conducted 14 vibration measurements with different initial processing conditions. An analysis of the obtained results was performed and appropriate comments were given showing the influence of processing parameters on vibrations.