Dental implants are titanium screws that are built into the bone of the upper or lower jaw and serve as a substitute for the lost tooth's root. They unite surgery, aesthetic dental medicine, prosthodontics, periodontics and dental laboratory. In the paper, the process of making and final result of an implant-prosthodontic procedure in the area of upper jaw's front is shown. Taking the occurrence of a defect of the buccal bone into account, the implant process had to be postponed and an augmentation of the residual alveolar bone was made. After six months, there was a new slot position of our implant and a satisfying amount of the new bone. During the preparation the conclusion is made that the bone quality is not the same as the original one, but with the slot that anchored about 4 mm, the implant will last in the long-term. After the next six months, the osseointegration was more than good and the fixed gingiva was formed. That was a good basis for making the first temporary replacement, modelling of the gingiva, making an individual upgrade of the implant with a temporary crown. What followed were print techniques with the conservation of the outside profile as well as the final print and making of the final implant-prosthodontic procedure that as a goal has predictable and with a long term prognosis, total reconstruction of current defects. The attributes of a natural, healthy and aesthetic gingiva were achieved. One has to have in mind that without a fitting bone support, it is impossible to achieve a wanted soft tissue harmony. With aesthetic analysis in dental medicine, the changes caused by age attack the teeth and parodontal structures as well as lips with the surrounding soft tissues. A regularly put in implant, guided regeneration of the soft tissues and techniques of caring for interdental papilla and finally, a proper choice of material lead to a harmonious implant-prosthedontic procedures and a satisfied patient.